Posts Tagged ‘controller’

Starlight – Controller PCBs Arrived!

No Comments »

Delivery of new PCBs was delayed because of the holidays but now I finally have a complete set so I can get to work on actual firmware.

Starlight Controller PCB
Starlight Controller PCB

Most of the parts are populated; all hand soldered because I was lazy to take out my hot air station. First attempt at TQFP soldering and all went well. Of course, nothing is complete without a bodge. I first soldered the 3.3V PIC instead of the 5V one so the power pad got lifted during desoldering. D’oh!
Starlight Controller PCB
Starlight Controller PCB


Starlight – Driver PCBs Arrived!

No Comments »

Santa made me very happy the other day when I saw an envelope in my mailbox. Since I ordered two different PCBs I wasn’t sure which one was in the envelope but it turned out it was the Driver PCB for my Starlight Controller project. Excuse the crappyness of my phone’s pictures but my digital camera is on holidays until further notice…

Starlight Driver PCB
Starlight Driver PCB
And a short rant time! While designing the PCB I used the terminal connectors’ datasheet as a guide for hole placement. Apprently, I was looking at the wrong datasheet because my connectors hang off the PCB by 1mm. Instead of 10mm hole-to-edge distance my connectors have 11mm distance. Normally this wouldn’t be a problem but since this PCB is supposed to go into a DIN-rail enclosure I could face some problems later…
Starlight Driver PCB


Starlight Controller – Introduction

No Comments »

A few years ago I made a simple stair lights controller for my parent’s house. Powered by a single PIC16F877 running at 20MHz it had 20 pwm channels and an RS485 interface that I never fully implemented (it simply wasn’t needed). Outputs were driven by BSP170 mosfets that turned out to be highly sensitive to ESD during soldering but pretty reliable when soldered to a PCB. As I was still learning how to program microcontrollers at that time I was fascinated by the things you could accomplish with a microcontroller so instead of having a simple one-by-one animation I decided that a wave-like effect would be better. Everything was placed on a single PCB with through-hole components and I was extremely proud of my work. This simple circuit ran flawlessly for the past 4 years until it met its archenemy – the water! As you already know, water doesn’t mix well with electronics and although nothing blew up (except the fuse in the power supply) there was severe oxidation all over the PCB and…well…now it’s time to make a new version. Bigger and better than before!

And so the Starlight project was born. Basic idea is something like this: provide a decent amount of PWM outputs for LED strips and avoid previous design flaws. And overcomplicate things, bwahahahaha!! Here are my initial specifications:

  • 24 PWM channels (because 24 is multiple of 8)
  • up to 1A of output current per channel
  • up to 4 digital inputs (for proximity sensors)
  • up to 2 analog inputs (for…something…a light sensor?)
  • CAN interface for future expansion
  • USB interface for configuration
  • a few status LEDs (because everybody loves blinking lights!)
  • optional configuration PCB for stand-alone configuration

I have already received one PCB for the PWM drivers and the controller PCB is on the way. Unfortunately, due to the holidays I didn’t have enough time to actually order parts so now I have to wait until everything arrives (a week or so). It’s very sad to look at the finished PCBs and not have the parts to solder…


  • 2014: Jan Feb Mar Apr May Jun Jul Aug Sep Oct Nov Dec
  • 2013: Jan Feb Mar Apr May Jun Jul Aug Sep Oct Nov Dec
  • 2010: Jan Feb Mar Apr May Jun Jul Aug Sep Oct Nov Dec